Custom Wiring Harness #56154

Installation was simple and the instructions were well laid out. After stretching the green right twilight wire and pulling it tight around the sharp sheet metal corners I had at least 3/16" it wire to spare.
I bought this light controller to replace the one from U-Haul that lasted 2 months (no warantee because I installed myself).
Hopefully this one will last longer.
Time will tell

I've been using Curt products for years, so I thought this would be just as simple as all the others. I've never used "quick" connect type harnesses before, so this was a first. Everything connected just fine. Only downside is that the harness wire for the passenger side tailight assembly is too short. I had to splice the wire to make it long enough to reach the tail light. I think it's something that should be address ed as the need to make a splice and add wire takes away from "quick connect". Other than that, it works well and I'l happy with it.

I have to start out by saying I have been using Curt products for four years on my wife and my cars, four total, and have never been dissatisfied. This harness assembly however, is too short to get from the install point on the Driver's side of the car to the passenger's. I don't know if it is because I have a 2014 Journey and there is no way to feed it up and over the crossbeams under the car or not. Either way, it needs about 6 to 8 inches of wire at the least to be long enough. I suggest not sticking the control box with the tape until you have it plugged in on both tail lights, and reinstall the passenger light. That's what worked for me. Hope it helps.