CURT class 1 trailer hitches are the lightest-duty hitches of our rear mount receiver lineup. They are engineered for reliability, welded together with quality American steel and blasted clean for a smooth finish. Tested to meet the strict demands of the industry, this CURT class 1 hitch has a capacity to tow up to 2,000 lbs. of gross trailer weight and 200 lbs. of tongue weight. This means it can handle a variety of small trailers such as single-axle utility trailers, canoe and kayak trailers, dirt bike trailers and more. It can also accept a hitch-mounted cargo carrier or bike rack, making it a very useful addition to cars with limited cargo space (NOTE: Never exceed the lowest weight capacity of any towing component; i.e. the vehicle, hitch, trailer, etc).
Class 1 hitches feature a 1 1/4" x 1 1/4" receiver tube opening and are typically mounted on compact cars, full-size cars and some smaller crossover SUVs, minivans and compact SUVs. This particular hitch is designed to be a custom-fit trailer hitch for certain years of the Honda Accord coupe or sedan (to verify your vehicle compatibility, see the CURT application guide at curtmfg.com). It features a square tube frame and comes with a hitch pin and clip and all necessary installation hardware.
Each CURT class 1 hitch is co-cured with a liquid Bonderite coating and a high-gloss black powder coat finish that provide a lasting defense against rust, wear and harmful UV rays. Like all CURT receiver hitches, this class 1 hitch is made right here in the USA and is backed by a one-year finish warranty and a limited lifetime warranty.
Electrical Connectors are vehicle specific.
Tell us your vehicle!
Submit Your Review
Wiring it #55502 - 2007 Honda Accord EX-L
In addition to installing your hitch #11327. I also installed your wiring kit #55502. Great kit with no issues. Installation instruction were every clear. Just one suggestion: Could add about 10 more inch to the four wire that go to the hitch, for my Honda Accord. Took me longer to remove the threshold panel and the felt trunk liner then installing the kit.
2007 Honda Accord EX-L) Hitch #11327 Installation
Your hitch #11327 is great. But the installation was a bit of an issue, only with your item #6. The hole in the frame was 1 inch in dia. and the CM-SP11 is 1 inch wide with square and tapered edges which would not fit through the hole in the frame. I had to hand file off 1/32 of an inch, plus round the edges slightly to get it to fit through the hole. Other then this one issue (two plates) the hitch is of every good quality at a every good price from Auto Anything and not hard to install.